InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
Bits of this value show "1" if the controller which has address corresponding
with the bit position plays active role in the power management. Bit 0
represents address 17 etc. This value contains information about controllers
with addresses 17-32.
13.1.12.10 Value: GL16
Bits of this value show "1" if the controller which has address corresponding
with the bit position has GCB closed. Bit 0 represents address 1 etc. This
value contains information about controllers with addresses 1-16.
13.1.12.11 Value: GL32
Bits of this value show "1" if the controller which has address corresponding
with the bit position has GCB closed. Bit 0 represents address 1 etc. This
value contains information about controllers with addresses 17-32.
13.1.12.12 Value: Breaker state
Code of the current state of the breaker control. The text representation of
each code can be obtained by the procedure described at the value Timer
text.
13.1.12.13 Value: Timer text
To Next Page
Loading...
