InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
BTB close/open command is received via communication line or
the input BTBButton is activated.
15.2.1.36 Binary output: MODES: Off mode
The output is closed while the controller is currently in OFF mode (either
switched by the mode selector on the front panel or by the input Remote
OFF).
15.2.1.37 Binary output: MODES: Man mode
The output is closed while the controller is currently in MAN mode (either
switched by the mode selector on the front panel or by the input Remote
MAN).
15.2.1.38 Binary output: MODES: Aut mode
The output is closed while the controller is currently in AUT mode (either
switched by the mode selector on the front panel or by the input Remote
AUT).
15.2.1.39 Binary output: MODES: Off mode
The output is closed while the controller is currently in OFF mode (either
switched by the mode selector on the front panel or by the input Remote
OFF).
15.2.1.40 Binary output: MODES: Man mode
The output is closed while the controller is currently in MAN mode (either
switched by the mode selector on the front panel or by the input Remote
MAN).
To Next Page
Loading...
