To Next PageTo Next PageWhy does the ComAp Controller show a 'charging system failure'?
If the ComAp Controller indicates a charging system failure, it means the alternator has failed to charge the battery. The suggested solution is 'ChrgAlternFail'.
What does it mean if the ComAp Controller displays 'oil pressure too low'?
If the ComAp Controller indicates oil pressure is too low because the oil pressure is less than the 'Sd Oil press setpoint', the suggested solution is 'Sd Oil Press'.
Why am I getting a 'wrong checksum of parameters' error on my ComAp InteliDrive Lite Controller?
A wrong checksum of parameters in the ComAp Controller typically occurs after downloading new firmware or changing a parameter. The suggested solution is 'ParamFail'.
What does it mean if the ComAp Controller displays 'no oil pressure information'?
If the ComAp Controller has no oil pressure information, it means there is no information from the binary oil pressure sensor. The suggested solution is 'Sd NotOilPress'.
Why does my ComAp InteliDrive Lite Controller show a 'service time alert'?
The ComAp Controller's service time alert activates when the engine's running hours reach the value set by the 'NextServTime' setpoint, indicating it's time for servicing. The suggested solution is 'WrnServiceTime'.
What causes an 'underspeed condition detected' on the ComAp InteliDrive Lite?
An underspeed condition detected by the ComAp Controller occurs during engine starting when the RPM reaches the 'Starting RPM' setpoint, the starter switches off, and the engine speed drops below the 'Start RPM' again. The suggested solution is 'Underspeed'.
What does 'RPM meas fail' mean on my ComAp InteliDrive Lite Controller?
If the ComAp Controller detects a running condition (oil pressure greater than starting oil pressure or energized D+), but the RPM does not appear to be valid (RPM less than starting RPM), the suggested solution is 'RPM meas fail'.
How does the ComAp InteliDrive Lite Controller detect a sensor fail?
Sensor fail is detected by the ComAp Controller when measured value is 6% out of selected sensor characteristic.
What happens when a warning comes up on the ComAp InteliDrive Lite?
When a warning comes up on the ComAp Controller, only alarm outputs and the common warning output are closed.
What happens when the ComAp Controller initiates a cooldown?
When cooldown comes up on the ComAp Controller, the engine is stopped slowly over cooling state.
General| Brand | ComAp |
|---|---|
| Model | InteliDrive Lite |
| Category | Controller |
| Language | English |
