ID-FLX Lite & Telecom Global Guide
47
This screen also contains Serial and Pwd. dec. (Password decode) numbers These numbers you can use in
case of forgotten passwords.
The last line on this screen signalize DiagData number. This number is giving specific diagnostics information in
case the program is from some internal reason blocked.
Note: If the password for the controller is forgotten, then is necessary to send Serial and Pwd. dec. numbers to
technical support team. They are able to renewed password for your controller.
Note: To switch to User interface screen use panel buttons: hold ENTER and press PAGE three times. Press
ENTER to leave this screen.
5.7 Display menus
There are 3 display menus available: MEASUREMENT and ADJUSTMENT and HISTORY in Engineer
interface and only MEASUREMENT in User interface.
Each menu consists of several screens. Press repeatedly PAGE button to select requested menu.
5.7.1 Switching between User and Engineer menus
Hold ENTER and then press PAGE to activate info Firmware screen and the panel LED test. Within 5s press
PAGE to switch to Language selection screen and the second time PAGE to switch to User interface selection.
Use ↑ and ↓ to select appropriate interface and press ENTER.
5.8 How to select the engine mode?
Use MODE→ or ←MODE to select requested engine operation mode (OFF – MAN – AUT).
5.9 How to view measured data?
1. Use repeatedly PAGE button to select the MEASUREMENT menu.
2. Use ↑ and ↓ to select the screen with requested data.
5.10 How to view and edit setpoints?
1. Use repeatedly PAGE button to select the ADJUSTMENT menu.
2. Use ↑ or ↓ to select requested set points group.
3. Press ENTER to confirm.
4. Use ↑ or ↓ to select requested set point.
5. Set points marked “*” are password protected.
6. Press ENTER to edit.
7. Use ↑ or ↓ to modify the set point. When ↑ or ↓ is pressed for 2 sec, auto repeat function is activated.
8. Press ENTER to confirm or PAGE to leave without change.
9. Press PAGE to leave selected set points group.
To Next Page
Loading...
