InteliMains 210 Global Guide
138
Example: When the controller, in AUTO mode, with a controller name of “InteliMains 210-Test”, with the
CM-GPRS module and access code “0” receives the SMS:
0 man, start, gcb close, gcb open, stop, auto
Controller mode will be changed to MANUAL mode. The engine will be started and GCB will close. Then
GCB will open, the engine will stop and it will go into AUTO mode again.
The controller will send back the SMS (controller will respond to SMS after every command has been
finished, not sooner.):
#InteliMains 210-Test: <OK>,<OK>,<OK>, <OK>,<OK>, <OK>
The value <OK> or <ERROR> means if the command has been performed succesfuly or not.
Emails
Event Email
The InteliMains 210 controller equipped with the CM-Ethernet communication module is able to send Event
Email according to the setting of setpoint:
Event Message (page 286)
Note: Firstly setpoints Email Address 1 (page 284) and SMTP Sender Address (page 279) (for CM-GPRS) or
SMTP Sender Address (page 289) (for CM-Ethernet) have to be adjusted.
Note: #Summer Time Mode (page 248) and Time Zone (page 286) have to be adjusted for correct time in emails.
Message structure:
Controller
-----------------------------------------------
Name: XXX
Serial number: XXX
SW branch: XXX
SW version: XXX
Application: XXX
Appl. version: XXX
Date: dd/mm/yyyy
Time: hh:mm:ss
Alarm list
-----------------------------------------------
Alarm 1
Alarm 2
Alarm 3
Events
-----------------------------------------------
hh:mm:ss Event 1
hh:mm:ss Event 2
hh:mm:ss Event 3
To Next Page
Loading...
Need help?
General
