C4-C5XL MK3 O&S
4-16
C4000MK3-OM-EN-11
Warning
Failure to support the fork carriage and block access to the fork controls
while working under the mast could result in serious injury or death.
3. Loosen the locking nuts a couple of turns, then loosen the adjustment
bolts a couple of turns. There are 4 wear pads on the mast carriage, 2
at the front and 2 at the back. Ensure that the nuts and bolts are
loosened off at all 4 wear pads.
4. Measure the distance (x) between the mast carriage side plate and the
channel at the front of the machine on both sides of the truck. The
distance (x) must be equal on both sides. Turn the front wear pad
adjustment bolts clockwise to push the wear pads up against the
channels. Adjust the wear pads until the distance (x) is equal on both
sides.
Wear
Pads
Channel Mast Carriage
Locking
Nut
Adjustment
Bolt
Fork
Carriage
Support
To Next Page
Loading...
