34
Chapter 7 Disassemble Procedure
The following section describes the disassembly and reassembly procedures for the monitor and its
components
7.1 Who Should Perform Repairs
Only qualified service personnel (biomedical engineers or technicians) should open the monitor housing,
remove and replace components or make adjustments. If your medical facility does not have qualified
service personnel, contact COMEN or your local COMEN representative.
Caution
High-Voltage – Voltages dangerous to life are present in the instrument when it is connected to the
mains power supply. Do not perform any disassembly procedures (other than server removal) with
power applied to the instrument. Failure to adhere to this warning could cause serious injury or
death.
Tools required
Screwdrivers
Small flat head screwdriver
Needle Nose Pliers
ESD mat and wrist strap
Cleaning agent
Tweezer
To Next Page
Loading...