CommScope Arris G34 - Page 45

Chapter 6:Configuring your Wi-Fi network
Figure 32: G34/G36 WPS device connection screen
4. Do one of the following:
■
Click the Wi-Fi Protected Setup (WPS) Enable button to turn ON WPS Wi-Fi
networking on your home network using the provided AP PIN number.
■
Click the Wi-Fi Protected Setup (WPS) Disable button to turn OFF WPS Wi-Fi
networking on your home network.
5. Do one of the following:
■
Click the WPS Pin Method Enable button to turn ON WPS Wi-Fi networking.
■
Click the WPS Pin Method Disable button to turn OFF WPS Pin connections.
6. To proceed with the PIN method, click the PIN Method option and then Enter the WPS
Pin number listed in the AP PIN field when you are prompted on your WPS device
screen.
7. Click PAIR to connect your WPS-enabled device.
8. Repeat steps 6 through 8 for each additional WPS-enabled device that you want to
connect to your Wi-Fi home network.
9. To proceed with the Push button option, click the Push Button (recommended) option
to connect your wireless client to your network.
10. Click PAIR to connect your WPS-enabled device.
SURFboard
®
G34/G36 DOCSIS
®
3.1 Wi-Fi
®
Cable Modem User Guide STANDARD Revision x.3 45