Section 16–Changing the Beamwidth (Fan)-Single SmartBeam™ ATC200-LITE-USB Teletilt
®
RET System
16-4 October 2014 Bulletin 639536 • Revision L
8. At the successful completion of an antenna movement, the Current BW/Fan field will update
to show the new pan azimuth and the New BW/Fan text entry box will be cleared in prepara-
tion for the next move (Figure 16-4). At this point, you may click on the Close button to exit this
screen and return to the main screen. Alternately, this process may be repeated to further adjust
the bore- sight (pan) or to reapply changes where movement had previously failed, such as a
temporary mechanical jam.
9. After closing the Set Actuator Position screen, the main screen will show the new Beamwidth
(Fan) setting in the Device Information list.
After all Beamwidth (Fan) adjustments are made and you are ready to end the program ses-
sion, a report can be saved to a file for future reference (see Section 18).
To Next Page
Loading...
