CommScope Era CAP M 9 - Connect the CAP M Power; Connect the Mains Power to the CAP M

M0201AJB Era
™
Medium Power Carrier Access Point Installation Guide
© October 2018 CommScope, Inc. Page 47
Installing CAP Ms
Connect the CAP M Cables
Completethefollowingproceduresintheorderinwhichtheyarepresented.Unlessotherwisenoted,each
procedureisapplicabletoasingularCAP
M(notinacascade),ortoaPrimaryorSecondaryCAPMina
cascade.
• "ObtaintheRequiredCableMaterial”onpage47
• "ConnecttheCAPMtoanRFAntenna”onpage48
• "ConnecttheCAPMtoaClassicCANorTEN”onpage48
• "ConnectaSecondaryCAPM(Optional)”onpage48
• "ConnectanExternalEthernetDevice(Optional)”onpage49.
Obtain the Required Cable Material
ContactyourlocalCommScopesalesrepresentativetoobtainthefollowingcomponents,asrequired,forthis
installation.
• Pertheinstallationplan,obtaineitherSingleModeFiber(SMF)orMultiModeFiber(MMF)thatisof
sufficientlengthtoreachfromtheCAP
MtotheClassicCANorTEN.
• ObtainatleastoneOpticalOCTISKit(PN7770612).AllinstallationsrequireoneOpticalOCTISKit,which
isincludedintheCAP
Mshipment.IfcascadingaSecondaryCAPM,asecondOpticalOCTISKitisrequired.
• ObtainSFP+Modulepairsthatareappropriateforthisinstallation.Table10identifiestheavailableSFP+
Modulesandthemaximumrangeforeach.
• IfconnectinganexternalEthernetdevicesuchasWiFiorIPcamera,anEthernetOCTISKit(PN7760652)
andappropriateCATcableforthedevice.
Do not remove protective caps from any of the connectors until instructed to do so.
Table 10. Supported SFP+ Modules
CommScope PN Description Maximum Range Notes
7660511 SFP+, 10GBase-SR, Multi Mode OM3 OM4
300m 400m
One placed in the TEN and paired with another in the
Classic CAN
7680813 SFP+, 10GBase-LR, Single Mode 10km One placed in the TEN and paired with another in the
Classic CAN