Concept Pro DEEP LEARNING PLUS - Page 45

45
DEEP LEARNING PLUS USER MANUAL
4. Configure the E-mail Event Action parameters as desired:
a. Name: Enter a custom E-mail Event Action preset name.
b. To: Enter recipient e-mail addresses. Multiple recipients may be added, but e-mail
addresses must be separated by commas.
c. Attach Snapshot: Select if image snapshot(s) of the event should be attached to the
event notification e-mail.
d. Snapshot Time Range: Select a time range for event snapshots to be included. Image
snapshots will be saved and sent for every second of the configured snapshot time
range (e.g., if set to 2 secs before and 5 seconds after each event e-mail will have 7
image snapshots attached). This increases the chance of a useful image snapshot
being attached to the event e-mail notification but may result in slower e-mail
transmission times.
e. Provider: Select a pre-existing e-mail provider or enter custom e-mail provider
settings (Gmail, Hotmail, Yahoo, Sureview).
f. SMTP Server: Enter the e-mail provider’s SMTP server address and port number.
g. Encryption: Select if TLS/SSL encryption must be used or turn encryption off.
h. Validate Server Certificate: Turn on if validation is required by the e-mail provider.
i. From E-mail: If applicable, enter the sender e-mail address.
j. SMTP Authentication: Check this option if server authentication is required.
k. Username: Enter the username for access to e-mail provider.
l. Password: Enter the password for access to e-mail provider.
m. Event Action Message: Select to use a pre-existing e-mail event template or
create a custom template to contain only the information required. Templates include
Sureview XML, JSON, JSON (pretty), Simple Message, Basic Message, and Object
List. Select any additional information tokens from the drop-down menu and click
<ADD> to add upon an existing or custom template.
n. Editable Box: Move tokens around and make the template fit a desired format.
o. Message Example: Displays an example of the configured e-mail template.
p. Send Example Message: Click <TEST> to send a test e-mail to the configured
recipients to confirm the e-mail server connection is working.
5. When all parameters are configured, click <APPLY> to save the settings.