Concept Pro DEEP LEARNING PLUS - Page 73

73
DEEP LEARNING PLUS USER MANUAL
ETHERNET2
Ethernet2 is the secondary RJ45 Ethernet port on the DL PLUS rear panel for connection to
another network that contains IP cameras or other video equipment that can be used as video
sources. To configure Ethernet 2 settings, please follow the steps below:
1. From the <SETUP> tab, select <NETWORK> - <IP SETUP> menu.
2. Select the <ETHERNET2> tab.
3. Configure the network settings as below:
a. DHCP: Select to dynamically and automatically assign key network settings to the
DL PLUS device according to the currently connected network environment. The DL
PLUS product is set to DHCP by default.
b. IP Address: Displays the current IPv4 address.
c. Subnet Mask: Displays the network subnet mask address.
d. Gateway: Displays the network gateway/router address.
e. 1st DNS: Displays the primary DNS address.
4. When finished, click <APPLY> to save these settings.