Condair UDC - Page 67

67Condair DCC and DCC-NA
Setting up the Timer program 2:
1. Press the < > button (press long) to switch the unit on.
2. Press the < > button for about 3 seconds "SEL" appears in the display.
3. Use the < > or < > button key to scroll the display until "Pro" appears, then press the < >
button.
4. Depending on whether or not timer operation is activated "PRO ON" or "PRO OFF" shows up in the
display.
5. Select "Pro 2" (Program 2) using the < > button and press the < > button to conrm.
6. Use the < > or < > button to set the start time to "17:00" (in steps of 15’), then conrm with the
< > button.
7. "Day1" (Monday) is ashing. Use the < > button to activate the time schedule for Monday, then
conrm with the < > button. "Day2" (Tuesday) is ashing. Use the < > button to activate the
time schedule for Tuesday, then conrm with the < > button. Repeat this procedure for "Day3"
(Tuesday) to "Day7" (Sunday).
8. Use the < > or < > button to select "OP" (operating mode), then conrm with the < > button.
9. Use the < > or < > button to select "ECO" (setback operation), then conrm with the < > but-
ton.
Activating/Deactivating timer operation:
1. Press the <On/Off> key to switch the unit on.
2. Press the < > button for about 3 seconds "SEL" appears in the display.
3. Use the < > or < > button to scroll the display until "Pro" appears, then press the < > button.
4. Depending on whether or not timer operation is activated "PRO ON" or "PRO OFF" shows up in the
display. Press the < > button.
5. Using the < > or < > button select "PRO ON" if you want to activate the timer operation or select
"PRO OFF" if you want to deactivate the timer operation. Conrm the selection with the < > but-
ton.
6. Press < > button two times to quit the programming mode.