Condair UDC - Page 81

81Condair RCC and RCC-NA
5.9.3.3 Conguring timer programs
Eight timer programs can be set. A timer program either switches the operating mode of the controller
or the setpoint. The week days a timer program is active can be selected individually (Day 1 = Monday,
Day 2 = Tuesday, ..., Day 7 = Sunday).
The following operating modes are available:
– On
The unit is active and attempts to reach the preset relative humidity at full power, if required (stan-
dard mode).
– ECO
The unit is in Eco Mode and humidies at a preset setpoint value of 30 %rH (setback operation).
– OFF
No humidication is taking place.
– no
No switching operation is taking place. The unit remains in the previous mode.
Programming example:
From Monday to Friday from 00:00h to 09:00h the unit should run in Eco Mode, from 09:00h to 17:00h the
unit should humidify to the target value and from 17:00h to 00:00h the unit should run in Eco Mode, again.
On Saturday and Sunday the unit should remain in Eco Mode the whole day long (00:00h – 00:00h).
Setting up this procedure requires two timer programs. The rst one to activate the standard operation
mode from Monday to Friday at 09:00h and the second one to activate the Eco Mode from Monday to
Sunday at 17:00h.
Setting up the Timer program 1:
1. Press the < > button (press long) to switch the unit on.
2. Press the < > button for about 3 seconds "SEL" appears in the display.
3. Use the < > or < > button to scroll the display until "Pro" appears, then press the < > button.
4. Depending on whether or not timer operation is activated "PRO ON" or "PRO OFF" shows up in the
display.
5. Press the < > button, "Pro 1" (Program 1) appears in the display. Press the < > button to conrm
program 1.
6. Use the < > or < > button to set the start time to "09:00" (in steps of 15’), then conrm with the
<Enter> key.
7. "Day1" (Monday) is ashing. Use the < > button to activate the time schedule for Monday, then
conrm with the < > button. "Day2" (Tuesday) is ashing. Use the < > button to activate the
time schedule for Tuesday, then conrm with the < > button. Repeat this procedure for "Day3"
(Tuesday) to "Day5" (Friday). Deactivate "Day6" (Saturday) and "Day7" (Sunday) using the < >
button.
8. Use the < > or < > button to select "OP" (operating mode), then conrm with the < > button.
9. Use the < > or < > button to select "On" (standard mode), then conrm with the < > button.