Over voltage and under voltage
Short code: #035#
This short code displays the under and over voltage limits.
Under voltage
If the average supply voltage measured on any phase by the meter is less than the minimum
voltage trip limit the meter will disconnect the consumers supply. The supply will remain
disconnected until such time as the supply voltage rises above this setting.
The minimum voltage trip limit is configurable in production and the feature can be disabled by
setting the limit to 0VAC.
Over voltage
If the average supply voltage on any phase measured by the meter is higher than the
maximum voltage limit, the meter disconnects the consumer's supply. The electricity supply
remains disconnected until the voltage drops below this limit.
The default maximum voltage trip limit is configurable; if this value is set to the maximum
value (example 420VAC), the feature will be disabled.
To Next Page
Loading...
Need help?
General
