Conlog BEC62 - Tamper Status; Number of Tamper Events

BEC62(08) technical manual
28
Tamper status
Short code: #008#
This function indicates if the meter has registered a tamper condition.
A “0” indicates the meter has not been tampered with.
A “1” indicates the meter has been tampered with.
If the meter is configured to display tamper, as is highly
recommended, the following indicates the meter has been
tampered.
Number of tamper events
Short code: #274#
The number of tamper events are recorded on the meter from the time the meter is commissioned.
Display indicates the number of tamper events.