Conlog BEC62 - STS Tokens; Meter Error Codes; STS Class One Tokens

55
BEC62 (08) technical manual
STS tokens
Meter error codes
Error code
Description
E01
Meter not initialised - contact Conlog
E02
Meter not calibrated - contact Conlog
E03
Internal error - contact Conlog
E04
No supply voltage present
E05
Reserved for future use
E06
Reserved for future use
E07
Communication error between the meter and UIU
E08
Wireless UIU error - contact Conlog
E09
Incompatibility between the meter and UIU
E10
Software error - contact Conlog
E20
Remote disconnection initiated
STS class one tokens
In line with the specification, a number of non-meter specific tokens are required as standard for all
STS compliant meters.
The STS information is accessible using Conlog’s short codes or by entering the specified 20 digit
token.
STS
token
Short
code
Description
STS0
000
Perform the STS dispenser test
STS1
001
Test the disconnect device of the meter (load switch test)
STS2
002
Display all icons on the user interface
STS3
004
View the meter or consumer's total consumption to date. The cumulative
totals are the Meter Total Consumption To Date (MTTD) and the User Total
Consumption To Date (UTTD)
STS4
005
View the key revision number and key type
STS5
006
View the tariff index
STS6
003
Test the input device (keypad) of the user interface
STS7
007
Display the maximum power limit setting
STS8
008
View if the tamper feature is enabled on the meter
STS9
050
View the instantaneous power
STS10
101
View the software version of the meter
STS11
010
Display the phase power unbalance limit