Contec BX220 Series User Manual

5. Each Component Function
58
BX-220 User’s manual
Table5.5 DVI–analog RGB conversion adapter
Connector type
DVI-I 29 pin
1
8
17
24
16
C1
C
2
C3
C
4
C5
5
1
6
10
11
15
15.00
[mm]
6.
20 5.80
39.40
30.00
33.0
0
Analog RGB signals
Pin No.
Signal name
Pin No.
Signal name
1
RED
9
+5V
2
GREEN
10
GND
3
BLUE
11
N.C.
4 N.C. 12 DDC DATA
5 GND 13 HSYNC
6
GND
14
VSYNC
7
GND
15
DDC CLK
8 GND
CA
UTION
-
If the OS is booted without connecting the display cable to the DVI interface, and then the display is
connected after the OS boots, the display may not be shown properly.
- When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen
mode.
This is because the frequency and resolution of Windows and MS-DOS (full-screen display) are the
same due to the screen settings while the display parameters are different.
For display, as only one parameter can be stored for one frequency or resolution, only either of
Windows or MS-DOS screen can be displayed properly.
In this case, change the resolution or display frequency of Windows so that it is not the same as for
the MS-DOS display.
- When using a digital display, an analog display may be detected even though no analog display is
connected.
- This will not affect how the digital display appears. However, change the multi-display settings as
necessary.
- To change the settings from digital output to analog output, change the settings from the standard
Windows properties screen.

Contec BX220 Series Specifications

General

Brand	Contec
Model	BX220 Series
Category	Touch Panel
Language	English