Contec BX220 Series User Manual

6. Appendix
74
BX-220 User’s manual
Table 6.3. Function of Each Register < 2 / 4 >
IIR : Interrupt Identification Register
D7 D6 D5 D4 D3 D2 D1 D0
Interrupt details
03FAH
I/O address Description
LCR : Line Contror Regester
03FBH
1: Do not generate interrupts
0: Generate interrupts
0 0 0 0 0
bit2
0
bit1
0
bit0
1
Priority Description
Interrupts are not generated.
Generated by overrun, parity, framing error or break
interrupt.
Cleared when the line status register is read.
Generated when the receive buffer register is ready.
Cleared when the receiving buffer is read.
Generated when the transmitter holding register is
empty. Cleared when the IIR is read or when
transmitted data is written to THR.
Modem
status interrupt is generated.
(CTS, DSR, RI, CD)
Cleared when the modem status register is read.
1 1 0
1 0 0
0 1 0
0 0 0
1 (high)
2
3
4 (low)
D7 D6 D5 D4 D3 D2 D1 D0
0 : 1 STOP bit
1 : 1.5 STOP bits at 5-bit length
2 STOP bits at 6-, 7-, or 8-bit length
0 : Disable parity
1 : Enable parity
0 : Odd parity
1 : Even parity
0 : Disable stick parity
1 : Enable stick parity
0 : Break signal off
1 : Send break signal
DLAB (Divisor Latch Access Bit)
In order to access the divisor latch register, you need to set the bit
to 1. To access another register, set the bit to 0.
D1
0
0
1
1
D0
0
1
0
1
Bit table
5
6
7
8

Contec BX220 Series Specifications

General

Brand	Contec
Model	BX220 Series
Category	Touch Panel
Language	English