4. BIOS Setup
32 User’s Manual
CRT/FPD : Specify the display type.
Choose from "CRT Only," "AUTO
Select," "SW Select," "VGA TFT,"
"SVGA TFT," and "XGA TFT." When
you are using only a CRT, select "CRT."
For others, set to "AUTO Select."
AUTO Select:
It automatically recognizes the type of
FPD with COM-port signals on the
FPD signal when PC startups. In case
of not connecting FPD to BOX-PC or
not turning on FPD, it will be CRT-
Mode. Also FPD will not be displayed.
CRT Only:
Select this option to use only a CRT.
SW Select:
Select this option to follow the S1
settings.
SVGA TFT:
800×600 TFT(IPC-DT/L40S(PC)T)
only. This option overrides the SW
settings.
XGA TFT:
1024×768 TFT(IPC-DT/H40X(PC)T)
only. This option overrides the SW
settings.
VGA TFT:
Currently, there is no panel link display
available that corresponds to the 640 x
480 TFT.
DOC Address : Set to "Disabled".
Watch-dog Timer: Specify the output status of the RAS
connector (PO2/WDT) signal during
BIOS startup.
Disable:
Sets the RAS connector's
To Next Page
Loading...
