3. Hardware Setup
20 User’s Manual
Installing the Hard Disk
(1) Connect the provided HDD cable to the hard disk (silicon
disk).
Note!
Connect the HDD cable in alignment with pins from the left
end of the connector on the HDD side.
Four master/slave setting pins are left unconnected on the
right side. Be aware that connecting the power with the
connector misaligned will damage the cable.
(2) By threading the cable through the hole on the base of the hard
disk bracket, fasten the disk to its bracket using four screws.
- Use the upper screw holes of the hard disk bracket.
- Fasten the disk using the outer or inner hole depending on the
model you are using. (The figure below shows an example
that uses the inner screw hole.)
(3) Connect the HDD cable to CN15 on the unit and fasten the
hard disk bracket to the unit using four screws.
To Next Page
Loading...
