4. BIOS Setup
34 User’s Manual
Advanced Window
Installed O/S: [Other]
Enabled ACPI: [No]
Reset Configuration Data: [No]
PCI Configuration
Cache Memory
Legacy USB Support: [Disabled]
I/O Device Configuration
Large Disk Access Mode: [DOS]
Local Bus IDE adapter: [Both]
PCMCIA ATA DISK [Disabled]
F1 Help
↓
Select Item -/+ Change Values F9 Setup Defaults
Esc Exit
←→
Select Menu Enter Select
Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main Embedded Advanced Security Power Boot Exit
Item Specific Help
Select the operating
system installed
on your system which
you will use most
commonly.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
↓
Figure 4.5. Advanced Window (Factory Settings)
Installed OS : Normally, set to "Other."
Enabled ACPI : Set to "No".
Reset Configuration Data: Resets the resources assigned to the PCI
and PnP devices.
Before installing the OS, set “Yes” to
reset the configuration. The setting
automatically returns to “No” after
rebooting.
PCI Configuration : Allows resources to be reserved for
legacy devices.
Cache Memory : Specify whether to enable or disable
cache memory.
Legacy USB Support : Set to "Disabled."
I/O Device Configuration: Set COM/LPT.
Large Disk Access Mode : Normally, set to "DOS."
Local Bus IDE adapter * : Sets the on-board IDE controller.
To Next Page
Loading...
