Contec IPC-BX/600(PCW) - Locations and Settings of Internal Connectors and Jumpers

3. Hardware Setup
18 User’s Manual
Locations and Settings of Internal Connectors and
Jumpers
When you remove the top cover and hard disk bracket, the
connectors, jumpers, and switches are laid out as shown in the
figure below:
CN15
654321
ON OFF
S1
87
JP2
1 2
3
JP1
1 2 3
M2
JP4
123
654321
ON OFF
S1
87
JP2
12
3
JP4
1 2 3
(A)
(B)
(B)
(B)
(A)
(B)
(A)
* The position of the jumpers mounted changes with kinds (A, B) of substrate.
JP1 is not mounted by A type.
Figure 3.3. Locations and Settings of Jumpers, Connectors,
and Switches inside the Top Cover