Need help?Do you have a question about the Conviron A1000 and is the answer not in the manual?
Describes the A1000's purpose for controlled plant growth and scientific experiments.
Explains manual structure, symbols, and formatting for clarity and user guidance.
Details essential information to provide when seeking technical assistance or troubleshooting support.
Specifies ideal location and environmental conditions for optimal chamber performance.
Defines minimum required space around the unit for proper air circulation and cooling.
Outlines electrical requirements, voltage tolerances, and circuit protection for the unit.
Details the utility connections and ports available on the rear of the A1000 chamber.
Provides instructions on how to adjust the unit's levelers for stability and proper drainage.
Describes the procedure for installing the condensate drip pan under the chamber.
Lists essential checks to perform before operating the unit for the first time.
Advises on initial operation and the importance of a break-in period for the equipment.
Provides steps to diagnose and resolve issues when the chamber fails to power on.
Offers solutions for common problems when the chamber is not cooling effectively.
Details the recommended procedures for cleaning the interior and exterior of the chamber.
Explains how to purge the water tank for periods of non-use to prevent issues.
Provides guidance on the proper disposal of the plant growth chamber components.
Illustrates and explains symbols used to warn of potential hazards and provide important information.
Highlights safety requirements for authorized personnel operating and maintaining the equipment.
Emphasizes safety precautions for qualified personnel during the chamber installation process.
Advises on pre-operation checks and safe practices during chamber use.
Provides instructions and precautions for replacing fluorescent lamps to ensure optimal performance.
Details maintenance for the humidity system when the unit is not in use.
Instructions for preparing the chamber and unpacking kit components before installation.
Lists all components included in the Tissue Culture (TC) kit for installation.
Details the installation of the support that directs airflow to the air shelves.
Explains how to connect and install the air shelves to the back wall plenum.
Describes how to install the brackets that hold the wire shelves in place.
Lists all components included in the Plant Growth (PG) kit for installation.
Details the installation of air filters and cooling fans for the PG kit.
Describes the installation of the bottom support for the back wall plenum.
Explains how to install the supports and canopies for the PG kit's lighting system.
Provides instructions for installing the wire shelves within the chamber.
Lists all components included in the Incubation (IN) kit for installation.
Details the installation of the support that directs airflow through the back wall plenum.
Describes the installation of wire shelves for the IN kit.
Explains how to install single lamp fixtures and their supports in the IN kit.
Provides instructions for installing multiple lamp fixtures on a single shelf.
Lists all components included in the Arabidopsis (AR) kit for installation.
Details the installation of the support for the back wall plenum in the AR kit.
Describes the installation of adjustable lamp canopies for the AR kit.
Provides instructions for positioning and securing lamp canopy supports and the canopy itself.
General| Chamber Volume | 1000 L |
|---|---|
| Application | Plant growth |
| Light Intensity | Up to 1000 µmol/m²/s |
| Control System | Microprocessor-based |
| Lighting | LED or fluorescent options |
| CO2 Control | Optional |
| Power Supply | 50/60 Hz |
To Next Page
