A1000 INSTALLATION, OPERATION, & MAINTENANCE MANUAL
February 2016 | 256574-ENG R01 7-1
7 MAINTENANCE
The A1000 chamber requires regular maintenance in order to continue performing to
specifications.
7.1 Cleaning
For interior cleaning please damp a clean towel or rag outside the unit, and carefully wipe the unit
down. Do not use abrasive cleaners. Detergents in low proportions are suitable for most cleaning
requirements.
Use glass cleaner on both the interior and the exterior of the glass window.
7.2 Water Reservoir
If the water system will be unused for a long period of time, purge the water tank located in the
mechanical compartment.
To purge the water tank:
1. SHUT THE CHAMBER OFF (with the switch button located between the door and front
support).
1. Lift the top cover, turn the breaker off, and disconnect the ground wire at the back of the
top cover.
2. Carefully remove the top cover.
3. Open the water reservoir lid.
4. Clean the water tank.
5. Ensure there is no water residue on the ultrasonic discs.
6. Replace the water reservoir lid (this is very important otherwise air from the unit will be
damped into the ambient at all times, and water may be splashed over electrical
components).
Never spray water directly into the unit using a hose.
The A1000 contain sensors and other electrical components that will be damaged by
direct contact with liquids.
To Next Page
Loading...
