Cornelius HELIX - Blender Operation

Helix Operator’s Manual
© 2012-2014,Cornelius Inc. All Rights Reserved - 21 - Publication Number: 621058497OPR
Blender Operation
No separate process is required to prepare the blenders for operation. The blenders
should be test operated to ensure they are working correctly before the unit is operated.
CAUTION:
!
Do not run blenders dry. Use a cup of plain water for testing.
From the Home Menu, select a drink and drink size to be poured. This pours a drink
and moves a blender up in preparation to blend. Once the blender shield has moved
up, a drink can be put in the cup holder to blend.
DAILY OPERATION
Once the unit is installed, it should be left on and the Main Screen is displayed.
Each day, wash all external surfaces with a mild detergent solution and rinse with clean,
po
table water. Dry all external surfaces with a clean, soft, dry cloth. Remove the cup rest
and wash it with the same detergent solution. Dry the cup rest thoroughly and replace it.
Unit Cleaning
The unit should be cleaned on a daily basis using the Daily Cleaning Menu. The
menu is accessed from the Menu Screen. The following list of supplies are needed
for this operation:
• Clean Cloths
• Rubber gloves
• Spray bottle with cleaning solution
• Spray bottle with sanitizer solution
• 2 clear cups and 2 red cups (supplied)
To complete daily cleaning, perform the procedure in the Unit Cleaning section.
Daily Cleaning Menu
There is a daily cleaning menu that is accessed from the Main menu by pressing the
Sanitize button.
To initiate the daily cleaning process, perform the procedure in Table 10.
Table 10.
Step Action
1 Wash and sanitize hands or use clean rubber gloves.
2 From the Main menu, press the Sanitize button.
3 Press the Menu button to access the Daily Clean screen, shown in Figure 18.
4
Press the Play button to start the process. Follow the steps shown on
the screen to complete the cleaning process.