Helix Operator’s Manual
© 2012-2014,Cornelius Inc. All Rights Reserved - 31 - Publication Number: 621058497OPR
Drain Tube Inspection
Check the drain tubes for clogs and aged tubing. If tubes are stained or brittle, replace
them with new tubing.
Condensation Inspection
Check for signs of condensation. Clean the area where necessary and replace insu-
lation in the proper locations.
Refrigeration System Inspection
Visually inspect the refrigeration system for signs of wear or leaks. Call service if
repairs are needed.
Overall Mechanical Inspection
Check unit for any unusual noise or rattles. Tighten any loose screws if necessary.
Auger Bearing Inspection
Check white upper auger bearings for wear. If bearings are less than 1/16” thickness,
replace the bearing. Refer to
Figure 29.
Figure 29.
To Next Page
Loading...
