Cornelius HELIX - Dispensing a Drink

Helix Operator’s Manual
Publication Number: 621058497OPR - 22 - © 2012-2014, Cornelius Inc. All Rights Reserved
Figure 18.
CAUTION:
!
Never use abrasive or chlorine-based cleansers on the unit.
If there is a system malfunction, refer to Unit Startup section on page 12 and reset
the switch.
Dispensing a Drink
To dispense a drink, perform the steps in Tabl e 1 1 .
5
Supplies needed are as follows:
Clean cloth
Spray bottle with cleaning solution
Spray bottle with sanitizer solution
2 medium size cups with cleaning solution
2 medium size cups with sanitizer solution
Table 10.
Step Action
Table 11.
Step Action
1
Place the desired size cup into the cup stand under the dispense noz-
zle, as shown in Figure 19.
2
Match the drink size to the cup selected by pressing the correct size on
the touch screen.
3
Select the desired flavor from the Main Screen, shown in Figure 20.
When the button is pressed, the syrup and ice dispense.
4
When the unit is done dispensing, place it in the designated blender, as
shown in Figure 21. (Screen indicates which blender to use.)
5
Press the Blend button (lower right or left corner of the screen) and wait
for the blend cycle to finish. Blender will stop and lift blade.