CP Plus Orange - Page 21

⚫ Table 1-4
Parameter
Description
System Time
In the System Time box, enter time for the system.
Click the time zone list, you can select a time zone for the system, and
the time in adjust automatically.
Do not change the system time randomly; otherwise the recorded video
cannot be searched. It is recommended to avoid the recording period or
stop recording first before you change the system time.
System Zone
In the System Zone list, select a time zone for the system.
Date Format
In the Date Format list, select a date format for the system.
Date Separator
In the Date Separator list, select a separator style for the date.
Time Format
In the Time Format list, select 12-HOUR or 24-HOUR for the time
display style.
DST
Enable the Daylight-Saving Time function. Click Week or click Date.
Start Time
Configure the start time and end time for the DST.
End Time
NTP
Enable the NTP function to sync the Device time with the NTP server.
Server
In the Server box, enter the IP address or domain name of the
corresponding NTP server.
Click Manual Update, the Device starts syncing with the server
immediately.
Port
The system supports TCP protocol only and the default setting is 123.
Interval (Min.)
In the Interval box, enter the amount of time that you want the Device to
sync time with the NTP server. The value ranges from 0 to 65535.
⚫ Step 3 Click Next button to save settings.
1.1.4.1.3 Holiday
⚫ Here you can add, edit, delete holiday. After you successfully set holiday information, you can view holiday
item on the record and snapshot period.
You can also configure holiday settings by selecting Main Menu > SYSTEM > GENERAL >
Holiday.
Step 1 Click Next.
⚫ The Holiday interface is displayed. See Figure 1-18.