If there are several HDDs installed to the Device, you can set one of
the HDDs as the redundant HDD to save the recorded files into
different HDDs. In case one of the HDDs is damaged, you can find the
backup in the other HDD.
⚫ Select Main Menu > STORAGE > HDD MANAGER, and then
set an HDD as redundant HDD.
⚫ Select Main Menu > STORAGE > SCHEDUE > Record, and
then select the Redundancy check box.
If the selected channel is not recording, the redundancy function
takes effect next time you record no matter you select the check
box or not.
If the selected channel is recording, the current recorded files will
be packed, and then start recording according to the new
schedule.
⚫ This function is for some series products only.
⚫ The redundant HDD only back up the recorded videos but not
snapshots.
You can set ANR (auto network resume) function.
⚫ The IPC continues record once the NVR and IPC connection
fails. After the network becomes normal, the NVR can download
record file during the offline period from the IPC. It is to guarantee
there is no record loss on current connected IPC channel.
⚫ Set the max. record upload period. Once the offline period is
longer than the period you set here, IPC can only upload the
record file during the specified period.
This function is for IPC that installed SD card and the record function
is enabled.
Define a period during which the configured recording setting is
active. See Figure 1-33.
The system only activates the alarm in the defined period.
To Next Page
Loading...
