112 • TST-902 Product Manual — Doc. 7750C
Perform a Factory Restore
If the TST-902 needs to be restored to its factory default settings, perform the following
recovery procedure.
CAUTION:Performing a factory restore returns all TST-902 settings to their default values
and removes any Extended Range (ER)RFgateway connections and Wi-Fi® network access
points that were previously added.
1. Use the included t-pin tool or a similar pointed object to press and hold the recessed Reset
button on the rear of the TST-902. The TST-902 will begin to reset.
2. Release the Reset button after the reset process begins.
3. Once the Crestron swirl logo is shown on the touch screen display, the reset process has
completed. Press and hold the Reset button again.
4. Repeat steps 1–3 to perform the reset process 10 more times (for a total of 11 times).
After the 11th time, the TST-902 enters recovery mode. A screen is displayed with an
option to restore the TST-902.
5. Tap the restore button to perform the factory restore.
The TST-902 will begin the factory restore process. Once the touch screen resets after this
process it can be configured as described in Initial Setup on page 83.
To Next Page
Loading...
