Crestron TST-902 - TST-902-DSW Wall Dock Installation

46 • TST-902 Product Manual — Doc. 7750C
TST-902-DSW Installation
Use the following procedures to install the TST-902-DSW.
NOTE:The TST-902-DSW wall dock is designed for flush-mount installation in a flat, vertical
wall structure. Installation of the wall dock requires additional mounting hardware (not
included):
l
The TST-902-DSW-BB and TST-902-DSW-BBIback boxes are available for both
framed and masonry construction.
l
The TST-902-DSW-PMK, TST-902-DSW-WMKM, and TST-902-DSW-WMKT
mounting kits are available for preconstruction and postconstruction applications that
do not require a back box.
In the Box
Qty. Description
1 TST-902-DSW, Wall Dock for TST-902
Additional Items
1 Connector, 2-Pin (2003574)
4 Screw, 6-32 x 1-1/2in., Flat Head,Phillips (2031703)
4 Plug, 0.35 x 0.50in., Black (2042641)
4 Screw, 6-32 x 3/4in., Pan Head, Phillips, Black (2007246)
1 Key, Release Lock (4522222)
Install the Mounting Hardware
One of the available TST-902-DSWmounting accessories (not included) must be installed prior
to installing the TST-902-DSW. Refer to the following installation procedures depending on the
chosen mounting hardware:
NOTE:Ensure the chosen mounting location allows for an air gap of at least 12in. (305mm)
in the wall cavity above and below the TST-902-DSW for heat dissipation.
l
For preconstruction applications where a back box will be fastened to the left or right-
hand stud of a framed wall prior to drywall installation, refer to TST-902-DSW-BB
Installation on page 53.