Crestron TST-902 - TST-902-DS Table Dock Installation

44 • TST-902 Product Manual — Doc. 7750C
TST-902-DS Installation
Use the following procedures to install the TST-902-DS.
NOTE:One TST-902-DSis included with the TST-902 touch screen. Additional
TST-902-DStable docks can be purchased to support multiple docking locations within an
installation.
In the Box
Qty. Description
1 TST-902-DS, Table Dock for TST-902
Additional Items
1 Power Cord, 6ft, 7in. (2.0m)(2001134)
1 Power Supply, 24VDC @0.75A, 100–240VAC(2048337)
Install the TST-902-DS
Place the TST-902-DS on a flat, level surface.The only required connection is from the fixed 6ft
(1.83m)power cord on the TST-902-DSto the included power pack.
NOTES:
l
Use Crestron power supplies for Crestron equipment.
l
The included power cord cannot be extended.