54 • TST-902 Product Manual — Doc. 7750C
2. Position the back box against the left or right side of the stud so that the extended edge
of the attached mounting plate covers the front end of the stud. Ensure the side of the
back box is directly against the side of the stud.
NOTE:If mounting the back box to the left side of a stud, the back box must be
rotated so that the extended edge of the attached mounting plate is on the right.
3. Verify that the back box is level prior to proceeding with the rest of the installation.
4. Attach the TST-902-DSW-BB to the left or right side of the stud with four standard
drywall screws or nails (not included).
5. Install the 8-8Bx1/4in. self-tapping screw in the rear of the back box mounting enclosure
as shown in the following illustration.
To Next Page
Loading...
