78 • TST-902 Product Manual — Doc. 7750C
1. Choose a mounting location that is free of any wiring, studs, or other obstructions. Make a
small hole in the drywall near the center of the chosen location to verify that it is suitable
for mounting.
2. Using a drywall saw (or equivalent), a level, and the provided cutout template, create a
cutout in the drywall for the mounting hardware. Refer to the illustration in Prepare for
Installation on page 76 for cutout dimensions.
NOTE:Ensure that the cutout is as level and smooth as possible before proceeding.
The mounting plate allows only for minor adjustments once installed.
3. Insert the trim ring into the drywall cutout.
To Next Page
Loading...
