Chapter 6. Manage / Configure the Switch
100
[Security Policy]
This is used to setup the IP addresses that can manage this switch. They have different access rights set in “Mode”.
And the remote management interfaces (Http/Telnet/SNMP) could be enable/disable for different administrators. This
function is for security policy of switch management.
Note:
Remember to enable at least one IP/Subnet with Modify right for Http/ Telnet/SNMP interface. Otherwise,
configuring switch from remote will become impossible. In that case, you can manage the switch from console only.
2). Mac Security Configuration
There are two Mac ID security modes for the switch. One is Static Mac ID Filter on Port, another is Dynamic Mac ID
Number Limit on Port.
To Next Page
Loading...
