Chapter 6. Manage / Configure the Switch
25
8. show command
This command is used to show current system information and system configuration.
Enter “show ?” at the prompt, the sub-command list will be shown.
# show ?
calendar Date and time information
dhcp-relay DHCP Relay Configuration
dot1x 802.1x content
gvrp GVRP configuration
history History information
interface Interface information
ip IP information
ip-filter IP Filter Configuration
lacp LACP statistics
line TTY line information
log Log records
mac-address-table Configuration of the address table
mac-security MAC Security Configuration
management Management IP filter
map Maps priority
mvr Show MVR Status
port Port characteristics
queue Priority queue information
radius-server RADIUS server information
running-config Information on the running configuration
rate-limit Configures rate-limits
snmp Simple Network Management Protocol statistis
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
system System information
trunk Trunk information
version System hardware and software versions
vlan Virtual LAN settings
With sub-commands, different configuration settings will be displayed.
More help information for them will be prompted with “show xxxx ?” (xxxx is the sub-command). For example,
entering “show ip ?” will get the prompt message...
# show ip ?
igmp IGMP snooping
interface Interface information
redirects Default gateway configured for this device
To Next Page
Loading...
