Chapter 6. Manage / Configure the Switch
75
# show ip igmp snooping mrouter
Type M'cast Router Ports
------ ----------------------------------------------------
static Eth 1/
show ip interface command will show current switch IP configuration.
For example,
# show ip interface
IP address and netmask: 192.168.1.12 255.255.255.0 on VLAN 1
show ip redirects command will show current IP gateway setting of the switch.
For example,
# show ip redirects
gateway: 192.168.1.254
8. show ip-filter command
This command is used to show current IP-Filter function status of the switch.
# show ip-filter
IP Filter Configuration
IP Address Filter: Disable
For showing filter IP address, “show interface switchport” command will show port settings one after another. And
“show interface switchport ethernet 1/x” command will show Port x settings.
9. show lacp command
This command is used to show current LACP configuration of the switch.
# show lacp ?
internal Shows config settings/operational state for local side
portstatus Shows LACP Port Status
sysid Shows channel groups system priority/MAC address
To Next Page
Loading...
