Chapter 6. Manage / Configure the Switch
78
show log configuration command is used to show current system log configuration.
For example,
# show log configuration
[System Log]
System Log Status : Enable
Log Level(0-7): 7
Remote Log : Disable
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
12. show mac-address-table command
This command is used to set Mac address table and configuration about it.
# show mac-address-table ?
aging-time Aging time for entries in the address table
address Address information
interface Ethernet or port channel-interface
multicast Knowns multicast addresses
<cr>
show mac-address-table command will show mac address table content.
For example,
# show mac-address-table
Interface MAC Address VLAN Type
=================================================
Eth 1/3 00-00-01-00-00-20 Learned
Eth 1/3 00-0E-A0-00-03-28 Learned
Eth 1/3 00-90-08-A7-76-C6 Learned
Eth 1/3 00-C0-F6-01-11-40 Learned
To Next Page
Loading...
Need help?
General
