Chapter 6. Manage / Configure the Switch
38
17 mac-address-table command
This command is used to configure functions for Mac address table of the switch. Entering “mac-address-table ?”,
the sub-commands will be shown.
(config)# mac-address-table ?
aging-time Aging time for entries in the address table
static Sets MAC address table static information
mac-address-table aging-time x command is used to set to aging time of the switch. The valid value of “x”(aging
time in seconds) is 10-1000000 and 0. If x=0, the aging operation will be disable.
mac-address-table static x-x-x-x-x-x interface ethernet 1/y command is used to assign a static Mac address x-x-x-
x-x-x to Port y of the switch. The static mac address will not be aging out by the switch.
18 management command
This command is used to setup the management interface security function. The management interface security
function can limit the IP / subnet / remote interfaces(http,telnet,snmp) / access right(view,modify) for management
from network. Different administrators could have different rights to manage this switch. This is for security of this
management switch. (Four user groups are supported for this function.)
Entering “management ?”, the sub-commands will be shown.
(config)# management ?
<1-4> Index
(config)# management 2 ?
enable Set enable for a specified set
ipaddr Set IP and net mask for a specified set
mode Set mode for a specified set
protocol Set protocol for a specified set
management x enable command is used to enable the security settings for some user groups (“x” is the index of the
user group). And no management x enable command can be used to disable it. And users for this setting are
allowed to manage this switch remotely.
management x ipaddr y.y.y.y z.z.z.z command is used to set the IP/subnet for some user groups (“x” is the index of
the user group, y.y.y.y is the IP address, z.z.z.z is the IP subnet mask). Users in this IP subnet will belong to this
users groups.
management x mode modify/view command is used to set the access right for some user groups (“x” is the index of
the user group). If “management x mode modify” command, users in this groups have “modify” right for
management. If “management x mode view” command, users in this groups have “view” right only.
To Next Page
Loading...
Need help?
General
