Chapter 6. Manage / Configure the Switch
26
And entering “show ip igmp ?” will get next help message...
# show ip igmp ?
snooping IGMP snooping configuration
And entering “show ip igmp snooping” will get the IGMP settings...
# show ip igmp snooping
IGMP Status: Disable
IGMP Querying: Disable
IGMP Querying: Disable
IGMP Query Interval: 125 seconds
IGMP Report Delay: 15 seconds
IGMP Query Timeout: 255 seconds
If the display is more than one console page, “Esc” can be used to break the display.
For the details, please refer to section 6.2.6 Show commands.
9. calendar command
This command is used to set the system time. It is entered in <hour minute second month day year> order.
For example,
# calendar set 10 30 0 october 15 2008
# show calendar
Current Time : 2008/10/15-10:30:18
It is 18 seconds passby after the setting command.
10. configure command
This command will change the console interface to configure mode. And the prompt will become “(config)#”. In this
mode, administrator can do system configuration of the switch.
The operation of configure mode will be described in next section.
“exit” command can be used to quit this operation mode.
To Next Page
Loading...
Need help?
General
