Chapter 6. Manage / Configure the Switch
86
[Trap Community]
ID Status Community IP Address
1 Disabled public 0.0.0.0
2 Disabled public 0.0.0.0
3 Disabled public 0.0.0.0
4 Disabled public 0.0.0.0
5 Disabled public 0.0.0.0
23. show sntp command
This command is used to show system time settings of the switch.
For example,
# show sntp
====================================
[Time Configuration]
====================================
Get Time By : Manually
Time Server : 220.130.158.54
Time Zone : Japan(+9)(37)
Current Time : 1970/01/01-10:08:38
====================================
24. show spanning-tree command
This command is used to show spanning tree configuration of the switch.
show spanning-tree command is used to show all spanning tree configuration (for bridge and ports).
show spanning-tree ethernet 1/x command is used show spanning tree configuration of Port x. (“x” is the port
number.)
For example,
# show spanning-tree ethernet 1/5
Bridge Port Number: 5
Port Priority (0..255): 128
Port State: Linked Down
Port Enable : Enabled
Is edge : No
Port Path Cost(1..65535): 19
To Next Page
Loading...
