Chapter 6. Manage / Configure the Switch
83
18. show queue command
This command is used to show traffic scheduling settings for priority queues on ports.
# show queue ?
bandwidth Shows weighted round-robin (WRR) bandwidth
mode Priority queue information
show queue bandwidth command is used to show weighting of priority queues for bandwitdh sharing of WRR
operation.
show queue mode command is used to show traffic scheduling mode for priority queues. One is Strict Priority
(higher priority always get bandwidth service first), another is WRR (Weight Round Robin, bandwidth is shared
between priority queues with weighting).
For example,
# show queue bandwidth
Queue Scheduling
WRR Setting Table
Priority Weight
Traffic Class 0 1
Traffic Class 1 2
Traffic Class 2 4
Traffic Class 3 8
# show queue mode
Queue mode: Strict
19. show radius-server command
This command is used to show settings for RADIUS Server of 802.1x function.
To Next Page
Loading...
