Chapter 6. Manage / Configure the Switch
81
For example,
# show management
[Management IP configuration]
Index Enabled Address / Net Mask Mode Http Telnet SNMP
====================================================================
1 Yes 0.0.0.0/0.0.0.0 Modify Yes Yes Yes
2 No 0.0.0.0/255.255.255.255 View No No No
3 No 0.0.0.0/255.255.255.255 View No No No
4 No 0.0.0.0/255.255.255.255 View No No No
====================================================================
15. show map command
This command is used to show 802.1P priority, DSCP priority, and port-based priority to priority queues mapping.
There are four priority queues on each port of the switch.
# show map ?
dscp IP DSCP priority map
port IP port priority
priority 802.1p priorities map
show map dscp command is used to show IP DSCP QoS function enable/disable status, and DSCP values(0~63) to
priority queue mapping on each port.
show map dscp ethernet 1/x command is used to show DSCP values(0~63) to priority queues mapping on Port x.
(“x” is the port number.)
show map port command is used to show connection port to priority queues mapping. This is called port-based
priority.
show map priority command is used to show 802.1P priority values(0~7) to priority queues mapping on each port.
show map priority ethernet 1/x command is used to show 802.1P priority values(0~7) to priority queues mapping on
Port x. (“x” is the port number.)
To Next Page
Loading...
Need help?
General
