Chapter 6. Manage / Configure the Switch
88
all Shows all Trunking Group Configuration
group Shows Each Trunking Group Configuration
show trunk configuration command is used to show trunk function enable/disable setting.
show trunk all command is used to show port member settings of all trunk groups.
show trunk group x command is used to show port member settings of Trunk Group x. (“x” is the trunk group
index.)
27. show version command
This command is used to show system version information and model information.
For example,
# show version
Firmware Version: 1.05.00
Number of Ports: 10
Model Name: 10G Switch SNMP Management
28. show vlan command
This command is used to show VLAN configuration of the switch.
# show vlan ?
private-vlan Private VLAN
id VLAN interface
name VLAN interface name
port-based Port-Based Virtual LAN Configuration
<cr>
show vlan command is used to show all 802.1Q VLAN settings (enable/disable, VLAN ID, VLAN Name, VLAN
Type, and Assigned ports).
show vlan id x command is used to show VLAN setting of VLAN x. (“x” is the VLAN ID).
To Next Page
Loading...
Need help?
General
