Chapter 7. Software Update and Backup
139
Chapter 7. Software Update and Backup
This switch supports software update and configuration backup/update/restore functions. It could be done in two ways.
1. From console when booting: by Xmodem protocol and doing by terminal program. This function can be used for
run-time code and boot code updating. (Boot code works only at boot time - before the main program starts.)
Press Ctrl-C when the switch is booting, the following message will be shown.
Boot Menu
===========================
0: Start the Run-time code
1: Upgrade Run-time code
2: Upgrade Boot Code
=> Select:
a. Start Run-time code : This option will continue the booting process.
b. Upgrade Run-time code : This option will try to update run-time code (main code) from terminal program with
Xmodem protocol. If this option is selected, the following message will be shown.
“Waiting to receive file by Xmodem ....”
Then user can select “Send File” function of terminal program and select Xmodem protocol and the update file,
then start the file upgrade.
c. Upgrade Boot Code : This option will try to update boot code from terminal program with Xmodem protocol. User
can select “Send File” function of terminal program and select Xmodem protocol and the update file, then start the
file upgrade.
2. From web browser: Doing by http protocol and by web browser. Please refer to the description of “Tools” function
in Section 6.4.12.
To Next Page
Loading...
Need help?
General
