Chapter 6. Manage / Configure the Switch
64
ip address dhcp command is used to enable DHCP client function. DHCP client function will try to get IP
configuration from DHCP server in network. And no ip address dhcp command can be used to disable it.
ip address x.x.x.x y.y.y.y command is used to set IP address of the switch on this VLAN. “x.x.x.x” is the IP address.
“y.y.y.y” is the subnet mask.
For example, “ip address 192.168.1.12 255.255.255.0” will set the IP address of the switch on this VLAN group for
remote management.
ip address renew command is used to refresh the lease time of the IP address got by DHCP. If IP configuration is
not got when boot-up, this command will try to get IP configuration again.
ip address release command is used to release current IP address got by DHCP. Then, you can try to get the IP
configuration again by “ip address renew” command.
8. no command
This command is used to disable a function or restore a setting to factory default of the switch.
(config-if)# no ?
ip Internet protocol
For example,
“ip address dhcp” command can enable DHCP client function on the VLAN group interface and “no ip address
dhcp” command can disable it.
6.2.5 VLAN Configuring Commands
Commands in Configuring Mode are for general switch settings. And its prompt is “(config)#”.
If the settings are for VLANs, it should enter VLAN configuring mode first by “vlan database” command in configure
mode. And its prompt will become “(config-vlan)#”.
To Next Page
Loading...
Need help?
General
