Chapter 6. Manage / Configure the Switch
76
show lacp internal command is used to show system priority and protocol enable/disable status of ports.
# show lacp internal
[Lacp Port Configuration]
System Priority: 65535
Port Protocol Enabled
------- ------------------
Eth 1/1 Disable
Eth 1/2 Disable
Eth 1/3 Disable
Eth 1/4 Disable
Eth 1/5 Disable
Eth 1/6 Disable
Eth 1/7 Disable
Eth 1/8 Disable
Eth 1/9 Disable
Eth 1/10 Disable
show lacp portstatus command is used to show LACP working status of ports.
# show lacp portstatus
[ LACP Port Status ]
Port Protocol Active Partner Port Number Operational Port Key
1 no
2 no
3 no
4 no
5 no
6 no
7 no
8 no
9 no
10 no
show lacp sysid command is used to show system ID of the switch for LACP protocol.
# show lacp sysid
65535
To Next Page
Loading...
