Chapter 6. Manage / Configure the Switch
29
queue Assigns priority queues
radius-server Configures login to RADIUS server
rate-limit Configures rate-limits
snmp-server Modifies SNMP server parameters
sntp Simple Network Time Protocol configuration
spanning-tree Configures spanning tree parameters
storm-control Configures storm control
trunk Configures trunk function
username Establishes user name authentication
vlan Switch Virtual LAN interface
---------------------------------------------------------------------------------------------------------
1 exit command
This command is used to leave current operation mode. Go back to last mode.
2 help command
This command is used to show all the available commands in this mode.
3 history command
This command is used to show the history of entering commands.
4 logout command
This command is used to logout from console interface.
5 quit command
This command is used to quit from console interface. It has the same function as logout.
6 automode command
With the command, user can select the operation mode of port when “auto” is set to disabled.
To Next Page
Loading...
Need help?
General
