Chapter 6. Manage / Configure the Switch
32
dot1x dynamic-vlan command is used to enable Dynamic VLAN function for 802.1x operation. If it is enabled, the
switch will assign the user to the VLAN assigned from RADIUS server. And no dot1x dynamic-vlan command can
be used to disable it.
dot1x guest-vlan x command is used to enable and select the VLAN for users fail to authenticated by RADIUS server.
“x” is the VLAN ID. And no dot1x guest-vlan command can be used to disable it.
dot1x max-req x command is used to set max request timeout count between the switch and RADIUS server before
authentication fail. The valid value of “x” is 1~10.
dot1x re-authentication command is used to force re-authentication on all ports.
dot1x system-auth-control command is used to enable 802.1x function on the switch. And no dot1x system-auth-
control command can be used to disable it.
dot1x timeout ... command is used to setup timeout values in 802.1x operation. Entering “dot1x timeout ?”, the sub-
command will be shown.
(config)# dot1x timeout ?
quiet-period Time after Max Request Count before gets new client
re-authperiod Time after connected client must be re-authenticated
server-period Time after an authenticator sends a RADIUS Access-Request packet to the authentication server
supplicant-period Time after an authenticator sends an EAP-Request/ MD5 Challenge frame to a supplicant
tx-period Time switch waits before re-transmitting EAP packet
dot1x timeout quiet-period x command is used to set the quiet time value between the switch and the user before
next authentication process when authentication fail. The valid value of “x” is 0~65535.
To Next Page
Loading...
Need help?
General
